Wood routers are great for a variety of tasks. Whether carving a piece of furniture or making a workbench, using a router bit is a great option.
Helpful tips for using wood router bit
Working with a wood router bit can be a fun and rewarding experience. But before you start, ensure you know these helpful tips. This article will give you some tips on how to use them effectively.
1. Using the right size bit
When choosing a woodworking tool, ensure it fits the project at hand. For example, a small table saw may be perfect for cutting down wooden boards, while a router is handy for finishing works. Wood routers have a range of sizes to choose from, but it’s always best to go with the smallest one possible because it makes the job easier and the work more precise. It would help if you also used a straight edge to measure the distance between the blade’s center and the fence – the smaller the gap, the less likely you will run over the material you’re working on.
2. Cleaning the blades regularly
If you want to keep working smoothly, clean the wood router bits after each use. Use a little oil and rub the surface carefully, ensuring not to touch the motor housing or the screw drive mechanism. Make sure the machine uses a variable speed motor – don’t buy anything else because it costs less.
3. Adjusting the depth setting whenever necessary
The depth control knob is located on the back side of the router. Once set correctly, you won’t need to adjust it often. However, if it gets stuck, loosen it and gently push it back into place again. If you notice the wood becoming duller than usual, check whether it’s been set improperly.
4. Turning off the power supply
It might seem obvious, but turning the power switch off is extremely important! When working with the tools mentioned above, it’s quite probable that they could cause severe injuries to anyone who happens to get caught under them. Always wear safety goggles and earmuffs before operating any machinery.
5. Changing the direction of rotation
To complete various types of projects, you may need to change the direction of rotation. To do this, turn the handle clockwise or counterclockwise until the desired result is achieved. Don’t forget to rotate the unit backwards before switching it off.
Bottom Line
In conclusion, the five most valuable tips for using a wood router bit are:
- Make sure the bit is of good quality.
- Use a durable paper or wood surface.
- Use a long and thin bit so your cuts are even.
- Use a light touch to avoid damage to the wood.
- Always test the bit before starting to make cuts.
Wood Router Tools Guide 